SODA ASH

Treat out hardness due to calcium in make-up water. Raise pH.

Eliminate calcium ions by removing them as insoluble calcium carbonate. Maximize the performance of bentonite and polymer product.

• Hardness (below 120PPM) and pH levels of make-up water should be checked prior to addition of Soda Ash
• Addition of Soda Ash should always be done prior to addition of bentonite or polymer to the fluid system
• Soda Ash should not be added at the same time as other drilling fluid components
• When treating make-up water pH ranges should be maintained between 8.5 – 9.5

_{The above are generalized concentrations of Soda Ash sodium carbonate to be added to fresh or salt water-based drilling fluids. The ultimate usage concentration will be based on local geology, water chemistry, application and mixing efficiency. In the event that further information is needed, please refer to the Product Data Sheet or contact your local Baroid IDP representative.}